6.5 HP StoreAll OS CLI Reference Guide

ibrix_phonehome
Manages the Phone Home configuration.
Description
When Phone Home is enabled, you can get remote support for StoreAll hardware and software
alerts using standard HP Insight Remote Support protocols. Systems are monitored continuously for
hardware or software failures, and HP can take the necessary corrective measures.
To enable remote support for MSA (9320 systems), use the ibrix_vs command to register the
MSA.
The chassis in X9720/9730 systems are registered automatically. Use the ibrix_chassis
command to see the current registrations.
:
Configuring Phone Home removes any previous StoreAll snmp configuration details and populates
the SNMP configuration with Phone Home configuration details. When Phone Home is enabled,
you cannot use ibrix_snmpagent to edit or change the snmp agent configuration. However,
you can use ibrix_snmptrap to add trapsink IPs and you can use ibrix_event to associate
events to the trapsink IPs.
Synopsis
Configure and enable Phone Home:
ibrix_phonehome -c -i <IP Address of the Central Management Server> -P
<Country Name> [-z Software Entitlement ID] [-r Read Community] [-w
Write Community] [-t System Contact] [-n System Name] [-o System
Location]
The command configures and enables Phone Home on all devices (servers, storage, and chassis)
present in the cluster. This command can also be used to modify the existing Phone Home
configuration.
For example:
ibrix_phonehome -c -i 99.2.4.75 -P US -r public -w private -t Admin -n
SYS01.US -o Colorado
Entitle a server:
ibrix_phonehome -e -h <Host Name> -b <Customer Entered Serial Number>
-g <Customer Entered Product Number>
The server must be present in the cluster. Enter the Host Name parameter exactly as it is listed by
the ibrix_fm -l command.
The customer-entered serial number and product number are used for warranty checks at the HP
Support queue. These numbers are on the information tag attached to the front panel of the
hardware.
Entitle storage (MSA):
ibrix_phonehome -e -i <Management IP Address of the Storage> -b <Customer
Entered Serial Number> -g <Customer Entered Product Number>
This command must be run for each MSA present in the cluster. The customer-entered serial number
and product number are used for warranty checks at the HP Support queue. These numbers are
on the information tag attached to the front panel of the hardware.
Entitle a chassis:
ibrix_phonehome -e -C <OA IP Address of the Chassis> -b <Customer Entered
Serial Number> -g <Customer Entered Product Number>
160 StoreAll commands