6.0 HP X9320 Network Storage System Administrator Guide (AW542-96009, December 2011)

IMPORTANT: The /opt/hp/hp-snmp-agents/cma.conf file controls certain actions of the
SNMP agents. You can add a trapIf entry to the file to configure the IP address used by the
SNMP daemon when sending traps. For example, to send traps using the IP address of the eth1
interface, add the following:
trapIf eth1
Then restart the HP SNMP agents:
service hp-snmp-agents restart
For more information about the cma.conf file, see Section 3.1 of the Managing ProLiant servers
with Linux HOWTO at Managing ProLiant servers with Linux HOWTO .
Start or restart Insight Remote Support services
Start or restart the following services:
• System Management Homepage:
# service hpsmhd restart
• SNMP Agent:
# service snmpd restart
• HP SNMP Agents:
# service hp-snmp-agents start
To ensure that hp-snmp-agents restarts when the system is rebooted, enter the following
command:
# chkconfig hp-snmp-agents on
Discover nodes on HP SIM or IRSS
For X9000 systems, HP Systems Insight Manager (SIM) uses the SNMP protocol to discover and
identify systems automatically. If desired, you can configure HP SIM to discover system-specific
network segments, a targeted host, or IP address ranges. For IRSS, see the HP Insight Remote
Support Standard A.05.50 Hosting Device Configuration Guide for more information. (Use the
link in the “Prerequisites” section to locate this guide.) For HP SIM, see the HP System Insight
Manager 6.x User Guide at: http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/
c02537452/c02537452.pdf
Configure Entitlements
Configure the CMS software to enable remote support for X9000 systems.
NOTE: If you are using IRSS, see “Using the HP Insight Remote Support Configuration Wizard”
and “Editing Managed Systems to Complete Configuration” in the HP Insight Remote Support
Standard A.05.50 Hosting Device Configuration Guide.
If you are using IRSA, see "Using the Remote Support Setting Tab to Update Your Client and CMS
Information” and “Adding Individual Managed Systems” in the HP Insight Remote Support Advanced
A.05.50 Operations Guide.
• Custom field settings for X9300/X9320
Servers are discovered with their IP addresses. When a server is discovered, edit the system
properties on the HP Systems Insight Manager. Locate the Entitlement Information section of
the Contract and Warranty Information page and update the following:
◦ Enter the X9000 enclosure product number as the Customer-Entered product number
◦ Enter X9000 as the Custom Delivery ID
22 Getting started