6.1 HP IBRIX X9000 Network Storage System File System User Guide (TA768-96061, June 2012)

To enable data retention on an existing file system using the CLI, run this command:
ibrix_fs -W -f FSNAME -o "retenMode=<mode>,retenDefPeriod=<period>,retenMinPeriod=<period>,
retenMaxPeriod=<period>"
To use the autocommit feature on an existing file system, first upgrade the file system to enable
autocommit:
ibrix_reten_adm -u -f FSNAME
Then set the autocommit period on the file system with the -o
"retenAutoCommitPeriod=<period>" option.
Viewing the retention profile for a file system
To view the retention profile for a file system, select the file system on the GUI, and then select
WORM/Data Retention from the lower navigator. The WORM/Data retention panel shows the
retention profile.
To view the retention profile from the CLI, use the ibrix_fs -i command, as in the following
example:
ibrix_fs -i -f ifs1
FileSystem: ifs1
Enabling file systems for data retention and validation 139