HP ExDS9100c/X9720 Network Storage System Controller Battery Customer Self Repair Instructions (448024-005, October 2011)

ManualsBrandsHP ManualsStorageHP X9320 IB 192TB Network Storage System

HP ExDS9100c/X9720

Storage System Controller

Battery Customer Self Repair

Instructions

Abstract

Replacement instructions for this component are available

in other languages. The translated versions are located at

http://www.hp.com/support/manuals.

Navigate to your product. On the manuals page, select

your language from the dropdown list in the Manual

language box and click the double right arrow next to this

box. The manuals page will refresh and display all

documents available in the selected language.

Printed in Singapore

*448024-005*

HP Part Number: 448024-005

Published: September 2011

Edition: 2

Customer self repair (CSR)

The following information is included in all CSR

documents:

• “Before you begin” (page

2)—Component-specific precautions or notices.

Be sure to read and observe these statements.

• “Verifying component failure” (page 2)—Before

replacing a component, confer with HP technical

support to verify that the hardware component

has failed and that you are authorized to replace

it. Verification procedures may include:

◦ Viewing LED illumination patterns on the

enclosure and the component.

◦ Viewing system event logs or other reports

generated by systems management tools.

• “Removing the failed component” (page

2)—Procedural steps to properly remove the

component, including illustrations.

• “Installing the replacement component” (page

2)—Procedural steps to properly install the

component, including illustrations.

• “Verifying component status” (page 3) — After

replacing the component, verify that the

replacement component is operating properly.

Verification procedures may include:

◦ Viewing LED illumination patterns on the

enclosure and the component.

◦ Viewing system event logs or other reports

generated by systems management tools.

Page 1

Summary of content (3 pages)

PAGE 1
HP ExDS9100c/X9720 Storage System Controller Battery Customer Self Repair Instructions Customer self repair (CSR) The following information is included in all CSR documents: Abstract • “Before you begin” (page 2)—Component-specific precautions or notices. Be sure to read and observe these statements. • “Verifying component failure” (page 2)—Before replacing a component, confer with HP technical support to verify that the hardware component has failed and that you are authorized to replace it.
PAGE 2
Table 1 Battery LED status (continued) Item Description Before you begin Green slow flash—Discharging, cache module being powered by battery; action required CAUTION: When handling system components, there is a danger to equipment from electrostatic discharge (ESD). Use proper anti-static protection at all times: • Wear an ESD wrist strap grounded to an unpainted surface of the chassis. • If an ESD wrist strap is unavailable, touch an unpainted surface of the chassis before handling the component.
PAGE 3
Disposing of an old battery WARNING! The controller uses Nickel Metal Hydride (NiMH) batteries. There is risk of explosion, fire, and personal injury if the battery pack is incorrectly replaced or mistreated. To reduce the risk of personal injury: • Open your management software utility and view the status of each controller and its batteries. • Do not expose to temperatures higher than 60oC • Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.