HP StoreAll OS 6.5.1 Upgrade Guide

lsmod|grep ipfs
ipfs1 102592 0 (unused)
If either grep command returns empty, contact HP Support.
7. From the management console, verify that the new version of StoreAll software FS/IAS is
installed on the node:
<ibrixhome>/bin/ibrix_version -l -S
8. If the upgrade was successful, failback the node:
<ibrixhome>/bin/ibrix_server -f -U -h HOSTNAME
9. Repeat steps 1 through 8 for each node in the cluster.
After all nodes have been upgraded and failed back, complete the upgrade.
Completing the upgrade
1. From the management console, turn automated failover back on:
<ibrixhome>/bin/ibrix_server -m
2. Confirm that automated failover is enabled:
<ibrixhome>/bin/ibrix_server -l
In the output, HA displays on.
3. Verify that all version indicators match for the nodes. Run the following command from the
management console:
<ibrixhome>/bin/ibrix_version -l
If there is a version mismatch, run the /ibrix/ibrixupgrade -f script again on the
affected node, and then recheck the versions. The installation is successful when all version
indicators match. If you followed all instructions and the version indicators do not match,
contact HP Support.
4. Propagate a new segment map for the cluster:
<ibrixhome>/bin/ibrix_dbck -I -f FSNAME
5. Verify the health of the cluster:
<ibrixhome>/bin/ibrix_health -l
The output should specify Passed / on.
Standard offline upgrade
This upgrade procedure is appropriate for major upgrades. The management console must be
upgraded first. You can then upgrade the nodes in any order.
Preparing for the upgrade
1. From the management console, disable automated failover on all nodes:
<ibrixhome>/bin/ibrix_server -m -U
2. From the management console, verify that automated failover is off. In the output, the HA
column should display off.
<ibrixhome>/bin/ibrix_server -l
3. Stop the NFS and SMB services on all nodes to prevent NFS and SMB clients from timing out:
The following steps are strongly recommended for shutting down processes in a proper manner
as to prevent data loss:
IMPORTANT: Alert users that SMB (CIFS), NFS and NDMP processes will be stopped for
proper cluster shutdown. Improper shutdown might result in file inconsistencies.
Upgrading the StoreAll software to the 5.5 release 33