HP StoreAll OS 6.5.1 Upgrade Guide

5. When the upgrade is complete, verify that the StoreAll software services are running on the
node:
/etc/init.d/ibrix_server status
The output will be similar to the following. If the IAD service is not running on your system,
contact HP Support.
IBRIX Filesystem Drivers loaded
ibrcud is running.. pid 23325
IBRIX IAD Server (pid 23368) running...
6. Verify that the ibrix and ipfs services are running:
lsmod|grep ibrix
ibrix 2323332 0 (unused)
lsmod|grep ipfs
ipfs1 102592 0 (unused)
If either grep command returns empty, contact HP Support.
7. From the management console, verify that the new version of StoreAll software FS/IAS has
been installed on the node:
<ibrixhome>/bin/ibrix_version -l -S
8. If the upgrade was successful, failback the node:
<ibrixhome>/bin/ibrix_server -f -U -h HOSTNAME
9. Repeat steps 1 through 8 for each remaining node in the cluster.
After all nodes have been upgraded and failed back, complete the upgrade.
Completing the upgrade
1. From the node hosting the active management console, turn automated failover back on:
<ibrixhome>/bin/ibrix_server -m
2. Confirm that automated failover is enabled:
<ibrixhome>/bin/ibrix_server -l
In the output, the HA column should display on.
3. Verify that all version indicators match for the nodes. Run the following command from the
active management console:
<ibrixhome>/bin/ibrix_version -l
If there is a version mismatch, run the /ibrix/ibrixupgrade -f script again on the
affected node, and then recheck the versions. The installation is successful when all version
indicators match. If you followed all instructions and the version indicators do not match,
contact HP Support.
4. Propagate a new segment map for the cluster:
<ibrixhome>/bin/ibrix_dbck -I -f FSNAME
5. Verify the health of the cluster:
<ibrixhome>/bin/ibrix_health -l
The output should specify Passed / on.
Upgrading the StoreAll software to the 5.5 release 39