6.0 HP X9720 Network Storage System Administrator Guide (AW549-96034, December 2011)

5. When the following screen appears, enter qr to install the X9000 software on the file serving
node.
The server reboots automatically after the software is installed. Remove the DVD from the
DVD-ROM drive.
Restoring the node configuration
Complete the following steps on each node, starting with the previous active management console
node:
1. Log in to the node. The configuration wizard should pop up. Escape out of the configuration
wizard.
2. Attach the external storage media containing the saved node configuration information.
3. Restore the configuration. Run the following restore script and pass in the tgz file containing
the node's saved configuration information as an argument:
/usr/local/ibrix/setup/restore <saved_config.tgz>
4. Reboot the node.
Completing the upgrade
Complete the following steps:
1. Apply any custom tuning parameters, such as mount options.
2. Remount all X9000 Software file systems:
ibrix_mount -f <fsname> -m </mountpoint>
3. From the node hosting the active management console, run the following upgrade script:
/usr/local/ibrix/setup/post_manualupgrade
This script turns automated failover back on, performs a backup of the upgraded configuration,
verifies versions, and verifies the health of the cluster. If the management console was in
maintenance mode on any file serving nodes, the console is moved to passive mode. The
90 Upgrading the X9000 Software