6.0 HP X9720 Network Storage System Administrator Guide (AW549-96034, December 2011)

[root@ib51-102 ~]# ibrix_fm -f

NAME IP ADDRESS

-------- ----------

ib51-101 10.10.51.101

ib51-102 10.10.51.102

[root@ib51-102 ~]# ibrix_fm -i

FusionServer: ib51-102 (active, quorum is running)

==================================================

File system unmount issues

If a file system does not unmount successfully, perform the following steps on all servers:

1. Run the following commands:

chkconfig ibrix_server off

chkconfig ibrix_ndmp off

chkconfig ibrix_fusionmanager off

2. Reboot all servers.

3. Run the following commands to move the services back to the on state. The commands do not

start the services.

chkconfig ibrix_server on

chkconfig ibrix_ndmp on

chkconfig ibrix_fusionmanager on

4. Unmount the file systems and continue with the upgrade procedure.

Moving the management console VIF to bond1

When the X9720 system is installed, the cluster network is moved to bond1. The 6.0 release

requires that the management console VIF (Agile_Cluster_VIF) also be moved to bond1 to enable

access to ports 1234 and 9009. To move the Agile_Cluster_VIF to bond1, complete these steps:

1. From the active management console, list all passive management consoles, move them to

maintenance mode, and then unregister them from the agile configuration:

# ibrix_fm -f

# ibrix_fm -m maintenance

# ibrix_fm –u <management_console_name>

2. Define a new Agile_Cluster_VIF_DEV and the associated Agile_Cluster_VIF_IP.

3. Change the management console's local cluster address from bond0 to bond1 in the X9000

database:

a. Change the previously defined Agile_Cluster_VIF_IP registration address. On the active

management console, specify a new Agile _Cluster_VIF_IP on the bond1 subnet:

ibrix_fm –t –I <new_Agile_Cluster_VIF_IP>

NOTE: The ibrix_fm –t command is not documented, but can be used for this

operation.

b. On each file serving node, edit the /etc/ibrix/iadconf.xml file:

vi /etc/ibrix/iadconf.xml

In the file, enter the new Agile_Cluster_VIF_IP address on the following line:

<property name=”fusionManagerPrimaryAddress”

value=”xxx.xxx.xxx.xxx’/>

94 Upgrading the X9000 Software