6.0 HP X9720 Network Storage System Administrator Guide (AW549-96034, December 2011)

4. On the active agile management console, re-register all backup management consoles using

the bond1 Local Cluster IP address for each node:

# ibrix_fm –R <management_console_name> —I <local_cluster_network_IP>

NOTE: When registering a management console, be sure the hostname specified with -R

matches the hostname of the server.

5. Return the backup management consoles to passive mode:

# ibrix_fm –m passive

6. Place the active management console into maintenance mode to force it to fail over. (It can

take up to a minute for a passive management console to take the active role.)

# ibrix_fm –m maintenance

7. Unregister the original active management console from the new active management console:

# ibrix_fm –u <original_active_management_console_name>

8. Re-register that management console with the new values and then move it to passive mode:

# ibrix_fm –R <agileFM_name> —I <local_cluster_network_ip>

# ibrix_fm –m passive

9. Verify that all management consoles are registered properly on the bond1 local cluster network:

# ibrix_fm –f

You should see all registered management consoles and their new local cluster IP addresses.

If an entry is incorrect, unregister that management console and re-register it.

10. Reboot the file serving nodes.

After you have completed the procedure, if the management console is not failing over or the

/usr/local/ibrix/log/Iad.log file reports errors communicating to port 1234 or 9009,

contact HP Support for further assistance.

Troubleshooting upgrade issues 95