6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

3 Configuring the cluster with the Getting Started Wizard
The Getting Started Wizard configures the cluster in a few steps. Be sure to have the necessary IP
addresses available.
NOTE: This wizard can be used only for 9300, 9320, and 9730 systems. If you are recovering
a server, do not use the Getting Started Wizard to join the server to the cluster. Instead, exit the
Getting Started Wizard and use the ASCII GUI Configuration Wizard to join the recovered server
to the cluster. See the procedure for recovering a file serving node in the Administrator Guide for
your platform.
Running the wizard
The Cluster Settings page asks for information to identify your cluster. Enter a name for the cluster
and specify the Cluster Management IP address.
30 Configuring the cluster with the Getting Started Wizard