6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

The wizard saves an installation log at /usr/local/ibrix/log/installtime.log on the
server where you ran the wizard. Click View Log to display the log.
When you click Finish to exit the wizard, the Fusion Manager is restarted. When the service is
running again, you can log into the GUI.
Troubleshooting the Getting Started Wizard
If you are unable to resolve an issue, contact HP support for assistance.
Cluster Settings page
The cluster name cannot be set
Probable cause: The command failed because of a timeout or other condition.
Troubleshooting steps: There may be network inconsistencies or an outage. Typically, a network
outage lasts only a few minutes. Check the network settings and retry the operation. You can also
use the following command to set the cluster name:
ibrix_fm_tune -S -o clusterName=<clusterName>,
fusionManagerPrimaryAddress=<Vif add>
The cluster name and IP address cannot be retrieved
Probable cause: The command timed out.
Troubleshooting steps: There may be network inconsistencies or an outage. Usually a network
outage lasts only a few minutes. Relaunch the wizard and try the operation again.
The VIF for the primary file server cannot be registered
Probable cause:
• The specified IP address is already assigned to another server.
• The Fusion Manager registration failed for the primary file server.
• The segment server registration failed for the primary file server.
Troubleshooting the Getting Started Wizard 35