6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

IMPORTANT: In previous releases, the X9720 system shipped with access to the management,
user and cluster networks through a single FSN bond. The field setup moved the user and cluster
network access to a separate bond once the connection between a FSN and the customer network
was established.
9730 systems default to a unified network configuration that places the chassis management
components on one subnet and the user/cluster components on a separate subnet. File serving
nodes are configured to access the user, cluster, and management networks through a single bond
attached to the user/cluster subnet. File serving node access to the components on the management
subnet requires a route in the customer network that connects the management and user/cluster
subnets.
IMPORTANT: The default unified network layout requires the customer to configure a router to
provide a level-3 route that connects the user/cluster subnet and the management subnet. The setup
process will not complete if the level-3 route is not in place for system installation. During the setup
process, the installer software makes sure that it can ICMP ping the OA to verify the route between
the user/cluster and management subnets. If it is unsuccessful, the installer software prompts the
user to correct the problem before proceeding.
IP address requirements
You will need the following IP addresses when you perform the installation for the unified network.
The HP StoreAll Storage Network Best Practices Guide describes the components in more detail,
and also lists IP address requirements for the other supported network layouts.
Table 2 IP addresses for unified network layout
Maximum number of
addressesMinimum number of addressesSubnetComponent
11 (one virtual IP address to assign to the entire
cluster for management use)
user/clusterCluster management VIF
Variable. At least 1
per node (16 included
in total)
2 ( virtual IP address for failover)user/clusterUser VIF
162 (one IP address per server to assign to the
network bond)
user/clusterFile serving nodes
1616managementiLO
88managementInterconnect bays
22 (OA primary and secondary)managementOA module
59 for maximum
configuration
31 for minimum configuration
You also need to provide the IP addresses of the DNS servers, NTP servers, and, optionally, the
default gateway.
HP recommends that you use sequential addresses for the blades, iLOs, and Interconnect.
Installation checklist
More informationTaskStep
“Configuring OA1 IP addresses for Onboard
Administrator” (page 45)
Configure active and standby IP addresses for Onboard
Administrator
1.
“Installing the latest StoreAll OS software release”
(page 47)
Install the latest StoreAll OS software release2.
44 Installing 9730 systems