6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

8. On the Network Settings: OA1 Active screen, select Accept All and press OK.
9. On the Enclosure Settings screen, select Standby OA or OA2 and press OK.
10. On the Network Settings:OA2 screen, navigate to Active IPv4 and press OK.
11. Set the IP address, subnet mask, and gateway (optional) and Accept the changes.
12. Back on the Network Settings:OA2 screen, navigate to Accept All and press OK.
The Main Menu reappears and the procedure is complete.
Installing the latest StoreAll OS software release
StoreAll OS version 6.3 is only available through the registered release process. To obtain the
ISO image, contact HP Support to register for the release and obtain access to the software dropbox.
Use a DVD
1. Burn the ISO image to a DVD.
2. Insert the Quick Restore DVD into a USB DVD drive cabled to the Onboard Administrator or
to the Dongle connecting the drive to the front of the blade.
IMPORTANT: Use an external USB drive that has external power; do not rely on the USB
bus for power to drive the device.
3. Restart the server to boot from the DVD-ROM.
4. When the HP Storage screen appears, enter qr to install the software.
Repeat steps 2–4 on each server.
Use a USB key
1. Copy the ISO to a Linux system.
2. Insert a USB key into the Linux system.
3. Execute cat /proc/partitions to find the USB device partition, which is displayed as
dev/sdX. For example:
cat /proc/partitions
major minor #blocks name
8 128 15633408 sdi
Installing the latest StoreAll OS software release 47