6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

25. Select a method to complete the installation:
• Continue with cluster setup at this console (Local web UI session)
• Continue with cluster setup remotely (Remote web UI session)
• Join this IBRIX server to an existing cluster
• Exit Now (You just wanted to setup networking)
To create a cluster, press F2 to use ASCII mode, which opens the "Form a Cluster - Step 2"
screen, described in “Creating the cluster on blade 1” (page 60).
IMPORTANT: To use the web UI, your cluster network must meet the following conditions:
• Network bond0 was configured without errors.
• Broadcast is enabled. The web UI relies on broadcast network traffic.
• The cluster has a single bond0 unified network for user/cluster traffic. (Using an external
management network for iLO traffic is acceptable.) The web UI assumes that a bond0
unified network should be used throughout the cluster.
• You entered a gateway IP address on the Server Setup screen.
If your cluster does not meet these conditions, select ASCII mode (press F2) to complete the
installation.
To proceed with the Getting Started Wizard, do one of the following:
• To continue using the console from which you are working, select Continue with cluster
setup at this console (Local web UI session). A message displays that the management
console GUI will be launched; click OK.
When the browser opens, a message may display that it is an untrusted connection.
Select Add Exception and then select Confirm Security Exception. The login window for
the StoreAll Management Console is displayed.
• To use another laptop or desktop that is connected to the network, select Continue with
cluster setup remotely (Remote web UI session). A message displays that the management
Starting the installation and configuring the chassis 59