6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

11. The wizard registers and starts a passive management console on the blade.
The installation is complete.
Troubleshooting
Install software cannot ping the OA
This condition can occur if OA2 becomes the Active OA. Configure the OA as follows to resolve
this condition:
1. From the Main Menu of the Insight Display, navigate to Enclosure Settings and press OK.
2. On the Enclosure Settings screen, select Active OA and press OK.
3. On the Network Settings: OA1 Active screen, select Network Properties and press OK.
4. On the Change OA Network Properties screen, set Enclosure IP to Enable and press OK to
Accept.
68 Installing 9730 systems