6.3 HP StoreAll Storage Installation Guide (TA768-96085, April 2013)

5. On the Network Settings: OA1 Active screen, select Accept All and press OK.
6. On the Enclosure Settings screen, select Standby OA and press OK.
7. On the Network Settings:OA2 screen, navigate to Active IPv4 and press OK.
8. Set the IP address, subnet mask, and gateway (optional) and Accept the changes.
9. On the Network Settings:OA2 screen, navigate to Accept All and press OK.
NOTE: The following conditions can also make the install software unable to ping the OA:
• VC is uplinked from X1 rather than X6 (be sure that X6 is used on 9730 systems)
• A gateway is not defined for OA or blade
• No L3 route from VC to OA
• Duplicate IP is used for blade or OA
• VC is already configured but blade 1 does not have a VC profile assigned
An 9370 blade boots, but the Installer cannot ping the VC
After the blade boots, the Installer reports that it cannot ping the VC and the ip addr command
reports only eth0 and eth1. Networks eth[2–7] are not visible. To correct this situation, complete
the following steps:
1. Power off the blade.
2. Log into the VC module from another system on the network.
3. Unassign the blade's profile.
4. Reassign the blade's profile.
5. Reboot the blade, and continue the installation.
Credential Manager initialization failed
If the default username or password is changed or the IP address of the OA is changed, the step
to initialize the Credential Manager will fail. To initialize the Credential Manager from the command
line, complete the appropriate procedure.
OA and VC have the same username and password.
Troubleshooting 69