HP XC System Software Installation Guide Version 3.0

11. Provide responses to install and configure LSF. This requires you to supply information about the primary
LSF administrator and administrator's password.
The user name lsfadmin is the default user name for the primary LSF administrator. If you accept the
default user name and a NIS account exists with the same name, LSF-HPC with SLURM will be configured
with the existing NIS account. You will not be prompted to supply a password for the lsfadmin
account. Otherwise, accept all default answers.
Output is similar to the following:
What name shall LSF use to uniquely identify this system?
No existing host names are allowed, and the name must be
less than 39 characters with no whitespace:
LSF System Name [hptclsf]: Enter
Enter the name of the Primary LSF Administrator. You can
configure additional administrators later, but this user
must exist now in order to be given ownership of the files
to be installed. If this user does not exist, it will be
created locally [lsfadmin]: Enter
The lsfadmin user does not exist. Do you want to
create this user now? (y/n) [y] Enter
Changing password for user lsfadmin.
New UNIX password: your_lsfadmin_password
Retype new UNIX password: your_lsfadmin_password
passwd: all authentication tokens updated successfully.
Executing the Platform LSF-HPC installation script (hpcinstall)...
Logging installation sequence in
/opt/hptc/lsf/files/lsfhpc/install-20051216023643/hpc6.1_hpcinstall/Install.log
1) linux2.6-glibc2.3-ia32e-slurm
Press 1 or Enter to install this host type: Enter
1
1
The sample command output was obtained from an Opteron-based system. Thus, the tar file
name is linux2.6-glibc2.3-amd64-slurm (the string amd64 signifies an Opteron- or
Xeon-based architecture). When an Itanium-based system is configured, the string ia64 is
included in the file name.
12. Follow along with the remainder of the system configuration process. This sample output is provided
for your information only; there is nothing else you have to do in this step. Despite some of the messages
shown in the command output, everything you need to install, configure, and verify LSF and SLURM is
described in this document.
Pre-installation check report saved as text file:
/opt/hptc/lsf/files/lsfhpc/install-20051216023643/hpc6.1_hpcinstall/prechk.rpt.
... Done LSF pre-installation check.
... Done installing hpc binary files "linux2.6-glibc2.3-ia32e-slurm".
... LSF configuration is done.
hpcinstall is done.
To complete your hpc installation and get your
cluster "hptclsf" up and running, follow the steps in
"/opt/hptc/lsf/files/lsfhpc/install-20051216023643/hpc6.1_hpcinstall/ \
hpc_getting_started.html".
After setting up your LSF server hosts and verifying
Task 7: Respond to Configuration Questions 57