HP XC System Software Release Notes for Version 4.0

13 Documentation
This chapter describes known issues and omissions in the HP XC System Software Documentation
Set and HP XC manpages.
13.1 HP XC System Software Administration Guide
The notes in this section apply to the HP XC System Software Administration Guide.In Section 11.3.2
“Using File Overrides to the Golden Image", the command in step 6 is incorrect. The correct
command is:
# ln -sf n8_override.master.0 n8.sh
13.2 HP XC Manpages
The following information was not added to the discover(8 ) manpage:
When the hardware configuration contains double density blade servers such as the ProLiant
BL2x220c, you must include the --nodesonly --extended
{contiguous|non-contiguous} option on the discover command line when you are
discovering nodes so that internal node numbers are assigned correctly:
• Using the --extended contiguous option results in naming the nodes serially, for
example: 1A, 1B, 2A, 2B, 3A, 3B...16A, 16B are n1, n2, n3, n4, n5, n6...n31, n32 respectively
• Using the --extended non-contiguous option results in naming the nodes in the order
they are connected to the Interconnect switches on the enclosure backplane, for example:
1A, 1B, 2A, 2B, 3A, 3A...16A, 16B are numbered as n1, n17, n2, n18, n3, n19... n16, n32
respectively.
13.1 HP XC System Software Administration Guide 43