HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

DescriptionStatusParameter name
Object ID of the SMI-S Enabled storage system to delete
Specify the object ID obtained from another CLI response. The
value is encoded by the CLI.
Optional
#
saobjid
#
Always specify either the serialnum and model parameters together, or the saobjid para-
meter by itself. Do not specify saobjid together with serialnum and model. Doing so will
result in an error.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
saobjid
Obtain this value from the execution result of the GetStorageArray command. Set the value
of objectID, obtained from the execution result, into the saobjid parameter.
Command execution example
hdvmcli DeleteStorageArray -o "D:\logs\DeleteStorageArray.log"
"serialnum=10001" "model=XP1024"
Command execution result
RESPONSE:
(Command completed; no data returned)
DeleteVirtualVolume
DeleteVirtualVolume deletes a THP/Smart volume.
NOTE:
This command can be used only with P9500 and XP24000/XP20000.
For P9500 and XP24000/XP20000, to delete a THP/Smart volume, the following conditions must
be satisfied:
• The THP/Smart volume does not have any paths.
• To delete specified THP/Smart volumes, Open Volume Management must be installed in the storage
system.
• The THP/Smart volume has a guard mode of Read/Write.
CLI Reference Guide 105