HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)
files for the corresponding products. For details about the sizes of other P9000 Command View
AE Suite product databases, see the manuals for those products.
CAUTION:
• The disk configuration must be the same on all the nodes that make up a cluster. Furthermore, the
installation destination for the P9000 Command View AE Suite products must also be the same
(including the drive letter and path).
• If you change some P9000 Command View AE Suite product settings after a cluster has been
created, specify the same settings for all the nodes.
• In this manual, a group of clustered services, the set of services for which failover is performed,
is called a
resource group
.
Setting up a cluster environment
This section describes how to set up a cluster environment by using Microsoft Cluster Service or
Microsoft Failover Cluster.
NOTE:
The cluster management application can be started with the following procedure:
If Microsoft Cluster Service is used:
Select Start > Settings > Control Panel > Administrative Tools > Cluster Administrator.
If Microsoft Failover Cluster is used:
Select Start > Settings > Control Panel > Administrative Tools > Failover Cluster Management.
Installing P9000 Command View AE Suite on cluster management servers (new
installation)
This section describes how to perform a new installation of P9000 Command View AE Suite on the
management servers in a cluster configuration.
CAUTION:
While reconfiguring the cluster system, do not access Device Manager, Tiered Storage Manager, or
Replication Manager.
Installing on the executing node (new installation)
To perform a new installation of P9000 Command View AE Suite on the executing node:
1. Bring the cluster management IP address and the shared disk online.
Setting up a cluster environment162