HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

amounts between the primary and secondary volumes. See the following table to set the appropriate
value:
Table 32 Values in the RETRY_WAIT parameter set for each storage system
Recommended value
(Units: seconds)
Descriptionstorage system
1
For a pair status to change, a wait time of at
least one second is needed.
XP1024/XP128 series
XP12000/XP10000/SVS200
HP XP24000
HP XP20000
Depending on the purpose of the processing, you can set the retry count and retry interval for checking
the pair status. If you want to set the retry count and retry interval for a specific purpose, add the
appropriate parameter in the RAID Manager-linkage definition file (DEFAULT.dat). If you do not
specify any purpose-specific parameters, the values of RETRY_TIME and RETRY_WAIT are used.
The following table shows the parameters you can add.
Table 33 Parameters in the RAID Manager-linkage definition file (DEFAULT.dat) (to specify the retry
count and interval for checking the pair status according to the purpose)
Specifiable val-
ues
(default)
DescriptionParameter
0 to 3600
(Value of
RETRY_TIME)
Specifies the maximum number of retries for
checking the completion of pair
resynchronization.
Specify this parameter to check the pair status
to make sure that backup processing or
resynchronization finishes (the completion of
paircreate
#1
or pairresync).
If you specify 0, Application Agent continues
to retry checking until it succeeds in checking
the status.
When adding this parameter, make sure that
the product of the RESYNC_RETRY_TIME-value
and RESYNC_RETRY_WAIT-value is sufficiently
larger than the time required to complete pair
creation.
RESYNC_RETRY_TIME
Preparation for using Application Agent122