HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Specifiable val-
ues
(default)
DescriptionParameter
0 to 360000
(Value of
RETRY_WAIT)
Specify the interval between retries that will be
performed to confirm whether the volume is
ready for resynchronization. This value must be
specified in units of 10 milliseconds. You need
to specify this parameter if you want to check
whether the pair status allows execution of
pairresync -restore for restoration.
When adding this parameter, you must
consider the following: the number of disks to
be restored, the disk sizes, and the difference
in data amounts between the primary and
secondary volumes at the time of the previous
backup
#2
.
RESTORE_DELAY_RETRY_WAIT
#1
In the PAIR_CREATE parameter of the RAID Manager-linkage definition file (DEFAULT.dat),
specify whether Application Agent is to automatically execute the paircreate command.
#2
The smaller the retry interval value (RESYNC_RETRY_WAIT, SPLIT_RETRY_WAIT, RE-
STORE_RETRY_WAIT, BUSY_RETRY_WAIT, or RESTORE_DELAY_RETRY_WAIT), the larger
the CPU load. Refer to Table 4-16 and specify a value appropriate to the storage system to be
used.
Specifying a retry count and interval for RAID Manager command busy retry
checking
If a RAID Manager command returns a busy status, Application Agent tries to execute the command
again. If you want to change the RAID Manager command retry count and interval, add the following
parameters:
Table 34 Parameters in the RAID Manager-linkage definition file (DEFAULT.dat) (to specify a retry
count and a retry interval for RAID Manager command busy status retries checking)
Specifiable values
(default)
DescriptionParameter
1 to 3600
(3)
Specify the maximum RAID Manager command busy
status checking retry count.
Specify this parameter to check the pair status if the
RAID Manager command returns a busy status.
BUSY_RETRY_TIME
CLI User Guide 125