HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

rolled forward by specifying the -recovery option. In this case, by applying the transaction logs
after backup, the database can be recovered to the state it was in immediately before the error
occurred.
The procedure for using the transaction logs of Exchange Server to restore backup data by using
roll-forward is described below.
The figure below shows a flow of operation using transaction logs.
Figure 118 Flow of operation using transaction logs
In the figure above, after the database is backed up from the primary volume to the secondary volume
at point A, the database is updated at point B. If an error occurs in a data file on the primary volume
at point C and then the database is restored from the secondary volume to the primary volume, the
database returns to the state it was in at point A. In this case, if the transaction logs from when the
backup was executed up until when the restoration command was executed are stored on the primary
volume, the database can be recovered to the state it was in immediately before the error occurred
(state immediately before point C) by executing roll-forward.
System configuration
The system configuration described in this operation example is shown below.
This example describes the procedure for restoring only the data in the mailbox store (Information
Store) out of the backup data obtained by VSS from the secondary volume to the primary volume,
CLI User Guide 415