HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Figure 37 Examples of a disk set configuration and of a relationship between a disk group and a disk
set
In this manual, unless it is necessary to distinguish between VxVM and LVM disk groups, both groups
are generically referred to as a disk group.
Application Agent can also simultaneously back up a basic disk and a disk group.
When a dynamic disk is being used, Application Agent supports both of the following configurations:
• One disk group is used as one logical volume.
• One disk group is divided into multiple logical volumes.
When a basic disk is being used, Application Agent supports only a configuration where one physical
disk is used as one logical volume (partition).
Note:
For Windows Server 2003 or Windows Server 2008, before using Application Agent, make
sure that Automatic mounting of new volume is disabled on the database server or
backup server.
Perform the following procedure to check the current status, and if Automatic mounting of
new volume is enabled, disable it:
1. Execute the diskpart command in the command prompt.
2. Enter automount to display the current status.
3. If Automatic mounting of new volumes enabled. is displayed, enter automount
disable to disable the setting.
4. Type exit to end the diskpart command execution.
CLI User Guide 75