HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 Administrator Guide (Web Version)

8. From the executing node, execute the following command to migrate the database to the shared
disk.
installation-folder-of-Common-Component\bin\hcmdsdbclustersetup /
createcluster /databasepath target-folder-for-re-creating-database /
exportpath target-folder-for-storing-database /auto
createcluster
This option changes the P9000 Command View AE Suite product in a non-cluster configuration
to a cluster configuration.
databasepath
Specify the folder in which you want to re-create the database. Use an absolute path to a
folder on a shared disk. The path name must not exceed 63 bytes.
The characters that can be used to specify the path are shown below. Additionally, back-
slashes (\), colons (:), or forward slashes (/) can be used as path delimiters.
A to Z a to z 0 to 9 . _
exportpath
Specify the folder in which you want to store the database. Use an absolute path to a folder
on a local disk. The path name must not exceed 63 bytes. The characters that can be used
to specify the path are the same as for databasepath.
auto
Automatically starts or stops P9000 Command View AE Suite services.
CAUTION:
• If you execute the hcmdsdbclustersetup command, the setting of the port number
used by HiRDB is changed back to the default (23032/tcp).
• If target-folder-for-storing-database already exists, empty or delete the
folder.
• Do not disconnect the shared disk from the executing node until the hcmdsdbcluster-
setup command finishes successfully.
• If you restart the server after the hcmdsdbclustersetup command has finished ab-
normally, the node to which the shared disk connects might switch to the standby node.
9. On the standby node, execute the following command to set the database on the shared disk as
the database to be used.
installation-folder-of-Common-Component\bin\hcmdsdbclustersetup /
createcluster /databasepath target-folder-for-re-creating-database /
exportpath target-folder-for-storing-database /auto
For details about the options that can be specified for the hcmdsdbclustersetup command,
see step 9.
For databasepath, specify the same folder as the one being used by the executing node to
re-create the database.
10. On both the executing and standby nodes, execute the hcmdssrv command to verify that the
P9000 Command View AE Suite product services are stopped.
Administrator Guide (Web Version) 189