HP StorageWorks P9000 for Business Continuity Manager Software Installation Guide (T5253-96052, May 2011)

LOGLEVEL(output-level) ~ <numeric character> ((0-3)) <<2>>
Specifies the log output level.
0
Logs are not output. If 0 is specified, it is difficult to determine the cause of a
communication failure or an error that occurs during execution of a Business
Continuity Manager agent command.
1
Communication-related messages (YKY300I, YKY301I, YKY304I, and YKY307I)
are output.
2
In addition to the messages that are output when LOGLEVEL(1) is specified, both
the YKY680I and YKY500I messages are output. The YKY680I message is output
when an error occurs during an update request for a copy pair configuration or a
copy pair status. The YKY500I message displays the results of updated configuration
files.
3
In addition to the information output with LOGLEVEL(2), BCM logs are output.
The following table shows the LOGLEVEL specification and the messages that are
output.
Table 30 LOGLEVEL Specification and the Output Messages
Output messagesLOGLEVEL
No output0
YKY300I, YKY301I, YKY304I, and YKY307I1
YKY300I, YKY301I, YKY304I, YKY307I, YKY500I, and YKY680I2
YKY300I, YKY301I, YKY304I, YKY307I, YKY500I, and
YKY680I
3
AUDITLOG(SYSLOG)
Specifies whether to output audit logs. When specified, the following additional information will
be output to SYSLOG:
• Name and return code of CLI commands that end with an error
• Name and return code of CLI commands that end successfully (only for operational commands)
Audit logs are not output if the AUDITLOG parameter is not specified. If the AUDITLOG parameter
is specified, operations are performed as if LOGLEVEL(2) or later was specified.
MODE(startup-mode) ~({EDIT|MONITOR}) <<MONITOR>>
Specifies the permission level at which the Business Continuity Manager agent starts.
EDIT – Allows definition, processing, and monitoring of copy groups.
MONITOR – Allows monitoring of copy groups.
LOCK(lock-mode) ~ ({PREFIX|CHECK|NONE}) <<PREFIX>> – Specifies the lock mode of the
configuration files. The LOCK parameter is valid only when MODE(EDIT) is specified. An error
occurs if the LOCK parameter is specified when MODE(MONITOR) is specified.
• PREFIX – Locks configuration files based on file name prefixes when the Business Continuity
Manager agent starts. Other users cannot update configuration files that are locked.
Creating Initialization Parameters 71