HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

NOTE:
When executing a backup using VSS, the same Service Pack should be applied on both the database
and backup server operating systems.
Table 29 Supported database and backup server OS combinations (when using a file system but not
VSS)
File sys-
tem type
Backup server OSDatabase server OS
NTFS
Windows Server 2003 (32-bit) SP2
Windows Server 2003 IPF SP2
Windows Server 2003 (64-bit) SP2
Windows Server 2003 R2 (32-bit) SP2
Windows Server 2003 R2 (64-bit) P2
Windows Server 2003 (32-bit) SP2
Windows Server 2003 IPF SP2
Windows Server 2003 (64-bit) SP2
Windows Server 2003 R2 (32-bit) SP2
Windows Server 2003 R2 (64-bit) SP2
Windows Server 2008 (32-bit) no SP or SP1,
SP2
Windows Server 2008 IPF no SP or SP1, SP2
Windows Server 2008 (64-bit) no SP or SP1,
SP2
Windows Server 2008 R2 no SP, SP1
Windows Server 2008 R2 IPF no SP, SP1
Windows Server 2008 (32-bit) no SP or SP1,
SP2
Windows Server 2008 IPF no SP or SP1, SP2
Windows Server 2008 R2 IPF no SP, SP1
Windows Server 2008 (64-bit) no SP or SP1,
SP2
Windows Server 2008 R2 no SP, SP1
Database and backup server requirements
This section describes database and backup server requirements. File systems are only supported
using the Application Agent CLI.
NOTE:
When using IPv6, both IPv4 and IPv6 must be enabled on the database and backup servers. You can
use IPv6 addresses only if they are global addresses.
Table 30 Database and backup server requirements (file systems)
Required programs
IPv6 sup-
port
Operating system
P9000 RAID Manager
Logical Volume Manager (Windows
LDM
3
or Veritas Storage Foundation
4
)
Application Agent v 7.0 or later
N
Windows Server 2003 SP2
5, 6, 7
N
Windows Server 2003 SP2 (IPF)
1, 5, 6, 7. 9
N
Windows Server 2003 SP2 (64-bit)
5, 6, 7, 9
Setting up Application Agent60