HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

DescriptionProperty
The number of retries attempted when Replication Manager cannot
establish a connection with HP StorageWorks P9000 for Business
Continuity Manager Software or P9000 mainframe agent. If 0 is
specified, the number of retries is unlimited.
Specifiable values: 0 to 100 (times)
Default value: 5
bcmif.ReconnectionCount
agentif.properties
The agentif.properties file is used to specify the values of properties necessary for the interface
between Replication Manager and a Device Manager Agent. Normally, you do not need to change
these values. To change the values, you need expert knowledge of Device Manager Agent. The
following table describes the available properties and settings.
Table 50 List of properties in the agentif.properties File
DescriptionProperty
The amount of time Replication Manager waits to connect to a Device
Manager Agent when collecting copy pair statuses. If 0 is specified,
Replication Manager waits until a connection is established without
timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
agentif.connectTimeout
The amount of time Replication Manager waits to receive a response
from a Device Manager Agent when collecting copy pair statuses.
If 0 is specified, Replication Manager waits for a response is without
timing out.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
agentif.responseTimeout
The amount of time Replication Manager waits to connect to a Device
Manager Agent when collecting configuration information or
performing copy pair operations. If 0 is specified, Replication
Manager waits until a connection is established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
hdvmagtif.connectTimeout
The amount of time Replication Manager waits to receive a response
from a Device Manager Agent when collecting configuration
information or performing copy pair operations. If 0 is specified,
Replication Manager waits for a response without timing out.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
hdvmagtif.responseTimeout
Configuration Guide 93