HP XP P9000 Command View Advanced Edition Suite Software 7.5.0-05 Release Notes (TB581-96374, November 2013)

Mozilla 1.7.13 (HP-UX 11i v3)
If the Device Manager GUI uses Mozilla 1.7.13 on HP-UX 11i v3 for PA-RISC, the IPv6 protocol cannot
be used to communicate with the Device Manager server.
Refreshing or configuration change of storage systems
When the refreshing or configuration change of the following storage systems is performed during
refreshing or auto refreshing of the same storage system, the subsequent refreshing or configuration
change might generate the KAIC05000-E error if the preceding refreshing does not succeed or the
preceding auto refreshing does not find configuration change:
• XP12000/XP10000/SVS200
• XP24000/XP20000
• XP P9500
If this occurs, perform the operation (refreshing or configuration change of the storage system) again.
Using the CLI GetLogicalGroup command to view the elements of logical groups
Note the following when using the CLI GetLogicalGroup command to view both logical group
information and information about the elements of logical groups:
• Do not place 16,384 volume paths or more in a logical group.
• Do not view 16,384 logical group volume paths or more at once.
• Delete unnecessary logical groups.
To confirm the number of paths in a logical group, view the logical group information without including
the paths of the elements in the logical group, and then check the number of volume paths in the logical
group.
If above steps are not followed, and the number of logical groups and the number of volume paths in
the logical groups becomes too large, a lot of memory will be used, which might cause the system
response time to increase and errors to occur.
Allocating volumes
In the Allocate Volumes, Allocate Like Volumes, or Add Storage for vCenter Plug-in combo dialog box,
if the number of pools or volumes in a storage system is large and Any is selected from the storage
system combo box, the KAIC15005-E error might occur and the selection of volumes that meet the
conditions might not succeed.
If this occurs, allocate volumes after selecting a storage system in the Resources tab.
Sorting multiple columns
If multiple columns are sorted, the KAIC16902–E, KAIC16193—E, or KAIC16009–E error might
occur.
If this occurs, reopen the screen and reduce the number of columns to be sorted.
Displaying logical group nodes in the Mobility tab
When the volume list in a logical group in the Mobility tab appears, the KAIC16902-E error might
occur.
If this occurs, the conditions of the logical group might be incorrect.
If this occurs again, review the conditions of the logical group from the Edit Logical Group dialog box.
34 Important considerations