HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

pvolPoolID=-1
svolSerialNumber=35001
svolArrayType=XP128
svolDevNum=128
displaySvolDevNum=00:80
svolObjectID=*****
svolPoolID=-1
fenceLevel=Never
replicationFunction=ContinuousAccessSync
status=1
muNumber=-1
copyTrackSize=14
splitTime=-1
remotePathGroupID=-1
pvolMngAreaPoolID=-1
svolMngAreaPoolID=-1
snapshotGroupID=-1
*****: The values are encoded by the CLI.
AddReplication (For Fast Snap)
The AddReplication command creates copy pairs. This section describes how to use the command
to create Fast Snap copy pairs.
To create copy pairs other than Fast Snap copy pairs, see “AddReplication” on page 337.
NOTE:
• This command can be used only with P9500.
• You cannot use the Device Manager CLI to perform any operations for consistency groups.
• You must specify a formatted LDEV. If you specify an unformatted LDEV, the copy pair will not be
created. Use the GetStorageArray command to check whether the LDEV has been formatted.
• The paired volume status is set to PAIR, and then changes to PSUS.
• You cannot create a copy pair for a LUSE volume.
• To create a cascade configuration by using the secondary volume (S-VOL) of Business Copy
Software as the primary volume (P-VOL) of Fast Snap, set the Business Copy Software copy pair
status to Split before creating copy pairs for Fast Snap. If the Business Copy Software copy
pair status is Pair, copy pairs cannot be created for Fast Snap.
There are two ways to create a copy pair.
• Method 1: Add a copy pair to an existing snapshot group. To use this method, execute the com-
mand in the following format:
hdvmcli [URL] AddReplication [options]
{hostid=target-host-ID|hostname=target-host-name}
pvolarraytype=model pvolserialnum=serial-number
pvoldevnum=device-number
[pvolpoolid=pool-ID]
svoldevnum=device-number
{snapshotgroupid=snapshot-group-ID|snapshotgroupname=snapshot-group-name}
replicationfunction=FastSnap
Command reference350