HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 CLI Reference Guide

Parameters
Table 117 GetReplicationControllerPair command parameters
DescriptionStatusParameter name
Serial number of the storage system that contains the main control
unit (MCU)
Optional
#
masterserial-
num
CU number of the MCU
Optional
#
mastercontrol-
lerid
Serial number of the storage system that contains the remote
control unit (RCU)
Optional
#
remoteserial-
num
SSID of the RCU
Optional
#
remotessid
Model of the storage system that contains the MCU
Optional
#
mastermodel
Family of the storage system that contains the RCU
Optional
#
remotefamily
Path group ID of the RCU
Optional
#
remotepathgrou-
pid
#
The following describes the parameter combinations that can be specified:
• You need to specify the masterserialnum, mastercontrollerid, remoteserialnum,
and remotessid parameters at the same time. If you do not specify them at the same time,
an error occurs.
• If you specify the mastermodel, remotefamily, or remotepathgroupid parameter,
you also need to specify all other parameters (masterserialnum, mastercontrollerid,
remoteserialnum, remotessid, mastermodel, remotefamily, and remotepath-
groupid). If you do not specify them at the same time, an error occurs.
• If you omit all the parameters, the command obtains the information about all replication
controller pairs.
Parameter values to obtain in advance
masterserialnum, mastercontrollerid, remoteserialnum, remotessid, mastermodel,
remotefamily, and remotepathgroupid
Execute the GetReplicationControllerPair command without specifying any parameters,
and then obtain the values from the execution result. Specify the value of masterSerialNumber
that is displayed as An instance of ReplicationControllerPair in the masterseri-
alnum parameter, the value of masterControllerID in the mastercontrollerid para-
meter, the value of remoteSerialNumber in the remoteserialnum parameter, the value of
remoteSSID in the remotessid parameter, the value of masterArrayType in the master-
model parameter, the value of remoteArrayFamily in the remotefamily parameter, and
the value of remotePathGroupID in the remotepathgroupid parameter.
Command execution example 1
This example obtains controller pair information for the MCU with CU number 10 in the storage system
with serial number 35001 and for the RCU with SSID 65534 in the storage system with serial number
15001.
Command reference362