HP StorageWorks P9000 Performance Advisor Software v5.2 Command-line User Interface Reference Guide (T1789-96316, May 2011)
Applies only when an output is selected.
TIP:
The software ignores an incoming header line in an input file or stream-in.
–header
Sends the configuration records to the management station.
TIP:
This parameter is effective only if all the input records are parsed without
error.
–send
In the form http://servername or https://servername.
TIP:
You can use https if your management station is set up for SSL.
–ms <management_sta-
tion_name>
The user name and password are the same as for the Configuration tab.–auth <user:password>
Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
–pf <password_file>
Displays the usage message; no parsing or sending is performed.–?
NOTE:
• Only one input source is accepted in one invocation.
• Output rows to the file or screen have fields separated by commas.
• Either -auth or -pf is accepted, but not both. The password file must be created using only the
encrypt command.
• There is no output to the file or to the screen unless requested.
• The commands are not case-sensitive.
• The order of command options does not matter.
• If command options are not provided, the streamed-in input is checked.
• For validity with no output presented or sent to the management station.
RAIDGRP
Syntax
raidgrp -dkc <serial #> -rg <raid group> [-auth <user:passwd>] [-ms
<URL>][-L] [-d<char>] [-hr] [-?] [-pf <password file>]
Supported disk array types
XP and P9000 disk arrays
HP StorageWorks P9000 Performance Advisor Software Command-Line User Interface Reference
Guide 35