HP StorageWorks P9000 Performance Advisor Software v5.4 Troubleshooting and FAQs Guide (T1789-96336, April 2012)

IP address or fully-qualified network name of management
station.
NOTE:
This host agent is configured automatically during host
agent installation. Configure this host agent manually
only when you want to change the management station
after installing the host agent.
The xpmgmtstationaddress.prp file needs to be
updated with the IP address of the management station, if
you want to use a different management station after
installing the host agent.
Discussion
Table 12 Configuring the host agent: ManagementStation.PollIntervalMilliSeconds
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\hostagent\config\
paxp_service.properties
If installed in a different location, the path is as follows: <Installation drive>:\
xppa\hostagent\config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/paxp_service.properties
File
This parameter is read and specified at run time.When Read
The frequency at which the Host station polls the Management station for updates. The
default for the polling cycle is 60000 (60 seconds).
Discussion
Table 13 Configuring the password required to access P9000 Performance Advisor
You can change the user and administrator passwords through the Security screen of P9000
Performance Advisor.
NOTE:
If you are the administrator, you can change other user(s) and administrator(s) passwords
on the Security screen of P9000 Performance Advisor, only if P9000 Performance Advisor
is enabled for Native authentication. You cannot change the passwords for domain and
system authenticated user accounts.
Discussion
Table 14 Disabling recover alarm notification
...%HPSS_HOME%/pa/properties/serverparameters.propertiesFile
HP StorageWorks P9000 Performance Advisor Software Frequently Asked Questions 93