HP XP P9000 Performance Advisor Software v6.0 User Guide

Table 14 Continuous access configuration data
DescriptionScreen element
Serial number of the primary XP or P9000 disk array
(primary data center).
Primary Array
LDEV configured as P-VOL on the primary data center.
Displays the LDEV number in cu:ldev format.
PVOL
Serial number of the secondary XP or P9000 disk array.Secondary Array
LDEV configured as S-VOL on the secondary data center.
Displays the LDEV number in cu:ldev format.
SVOL
Current replication link status of the P-VOL or S-VOL on the
selected XP or P9000 disk array. The replication link status
Pair Status
shown is corresponding to the continuous access
transactions happening on the selected XP or P9000 disk
array, and can be one of the following:
SMPL
COPY
PAIRED
Pair Suspend
Pair Suspend Error
Pair DUB
Reverse Copy
Pair SideFile 30% over
Pair SideFile over Suspend
SVOL Swap ready Suspend
Unknown
Type of volume (PVOL or SVOL) configured on the primary
data center.
Volume Type
Thick or Thin, indicates virtual volume or physical LDEV.Provision Type
Failed or Active.
NOTE: When Continuous access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the CA Link status as NA - Not Applicable.
CA Link Status
Alarm configuration for the CA pair status. HP XP P9000
Performance Advisor retrieves the CA pair status during
Pair Status Alarm
each performance cycle. If there is a change in the pair
status from the previous performance cycle, an email
notification is sent to the email address specified on the
Email Settings screen. These notifications are not sent if
there is an intermediate change in the pair status during a
performance cycle.
Number of active continuous access paths from a PVOL to
SVOL.
No. of Paths
NOTE: When Continuous Access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the status of the number of paths as NA -
Not Applicable.
Viewing continuous access data for P9000 disk arrays 201