HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 37 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ21x – YKZ24x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Check that the value is specified according to the
following rules:
• The command control address must consist of 2
digits.
• The control unit number must consist of 2 digits.
• The SSID must consist of 4 digits.
• The storage system serial number must consist of
5 digits.
• The device number must consist of up to 4 digits.
name
REXX variable name
value
Value
pair-index
See the pair index description in
the explanation of the YKE003E
message.
#
If this message is output while the YKLOAD
command is being executed, the RC is 44.
The time assigned to the ATTIME parameter has
elapsed. Processing will continue, ignoring the
specification of the ATTIME parameter.
The time specified with ATTIME has
past. The specification of ATTIME is
ignored.
YKZ229I MSG SC=0
RC=0
Processing for the volume was skipped because the
status of the volume did not allow this command to
Management for the relevant volume
was skipped. DEVN
device#(SN,CU#,CCA#)
YKZ230W MSG SC=4
RC=4 (pair-index)
be executed. If 0 is displayed in the location that
indicates the copy pair corresponding to the
pair-index, multiple volumes within the copy group
have been skipped.
Change the status of the copy pairs to a status that
allows this command to be executed.
device#
Device number
If the device cannot be identified,
**** is displayed.
SN
Storage system serial number
If the device cannot be identified,
************ is displayed.
CU#
Control unit number
If the device cannot be identified,
** is displayed.
CCA#
Command control address number
If the device cannot be identified,
** is displayed.
pair-index
List of Messages 125