HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 37 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ21x – YKZ24x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Correct the contents of the configuration file.
name
REXX variable name
#
If this message is output while the YKLOAD
command is being executed, the RC is 44.
Suspension initiated by YKSUSPND ATTIME is still
in effect. Copy pair operation is cancelled.
ATTIME SUSPEND remains in place.
Pair operation process is canceled.
YKZ238E MSG SC=36
RC=44
Re-execute the command after YKSUSPND ATTIME
processing ends.
The specified copy group is not a Cnt Ac-S Z with a
C/T group ID specified.
The specified Copy Group has no
CA Synchronous Group.
YKZ239E MSG SC=48
RC=48
Confirm that the copy group is a Cnt Ac-S Z copy
group with a consistency group ID specified and is
a Cnt Ac-S Z copy group for which the Open/MF
Consistency attribute is not set. After that, re-execute
the command.
A copy pair corresponding to the device number
specified in the DEVN parameter was not found in
the copy group.
The specified pair was not found in
the Copy Group.
(DEVN=P-VOL-device-number,
S-VOL-device-number)
YKZ240E MSG SC=48
There is no volume eligible for I/O issuance.No I/O issued volume is in Copy
Groups.
YKZ241W MSG SC=4
RC=0
Check the volume status, correct errors involved in
the configuration or execution conditions if any, and
then re-execute the command.
You cannot execute the YKRESYNC command to
change the copy direction before suspension,
The pair needs to be swapping, but
is not.
YKZ242E MSG SC=48
RC=48
because the copy pair status is not SWAPPING or the
status of the copy pairs has not been acquired.
Check the status of the volumes in the copy group,
correct the YKRESYNC command parameter
specification, and then re-execute the command.
When executing the YKRESYNC command with the
FORWARD/REVERSE parameter, execute the
YKQUERY command or YKEWAIT command to
acquire the status of the copy pairs immediately
before the YKRESYNC command.
ATTIME or CANCEL is specified together with SVOL.Supplied parameters invalidYKZ243E MSG SC=48
RC=48
Correct the YKSUSPND command parameter values,
and then re-execute the command.
The specified storage system does not exist in the
route list.
Storage system serial-number is not
found in Routelist.
YKZ244E MSG SC=36
RC=36
serial-number
Storage system serial number
The combination of the specified command or the
operand, and copy group attribute is invalid.
CopyGroup attribute combination is
invalid.
YKZ245E MSG SC=48
RC=48
Check the configuration file to make sure that the
configuration allows command execution, and
execute the command again.
List of Messages 127