HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YK80x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
BCM Monitor set the monitoring status of the copy group cgid to
the status status.
time Set MONITOR=-status
for Copy Group 'cgid'.
YK8047I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
status
• START: The monitoring status of the copy group was set to
ACTIVE.
• STOP: The monitoring status of the copy group was set to
INACTIVE.
BCM Monitor set CYCLETIME to the value identified by cycletime.time Set CYCLETIME to :
cycletime.
YK8048I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
BCM Monitor set WAITTIMEOUT to the value identified by timeout.time Set WAITTIMEOUT to :
timeout.
YK8049I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
BCM Monitor set MSGLEVEL to the values identified by lvllog and
lvlcons.
time Set MSGLEVEL to :
MSGLEVEL=lvllog,lvlcons.
YK8050I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
lvllog
Level of messages to be output to SYSTSPRT
lvlcons
Level of messages to be output to the console
BCM Monitor resumed processing.time BCM Monitor resume
monitoring.
YK8054I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
List of Messages 13