HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 40 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ27x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Items that do not match
COPYTYPE: copy type
GROUPID: consistency group ID,
or Open/MF Consistency attribute
PAIR: copy pair configuration
device#
Device number
If the device cannot be identified,
**** is displayed.
SN
Storage system serial number
If the device cannot be identified,
************ is displayed.
CU#
Control unit number
If the device cannot be identified,
** is displayed.
CCA#
Command control address number
If the device cannot be identified,
** is displayed.
For the port numbers and number of physical paths,
update the REXX variable, which indicates the port
Variables were changed for the
number of paths or portID.
YKZ272W MSG SC=8
RC=8
numbers and number of physical paths, to match the
settings on the storage system.
No paths to be operated exist within the range
specified by the parameter.
No path to be operated exist within
the range specified by the supplied
parameter.
YKZ273E MSG SC=36
RC=36
Check the parameters specified during command
execution, the path set name specified during the
YKLOAD command execution, and the attributes of
the path set (path type, shared attributes, storage
system serial numbers, and CU numbers).
In the logical path definition for FORWARD index1,
the index2 and index3 port numbers are duplicated.
Duplicate ports exist in FORWARD.YKZ274E MSG SC=36
RC=36 (index1, index2,
index3)
Delete one of the definitions or make sure that the
duplicated port numbers are correct, and then
re-execute the command.
index1
Index number of the duplicated
logical path
index2
Index number of one of the
duplicated ports
index3
Index number of the other
duplicated port
138 Messages