HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 40 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ27x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
In the logical path definition for REVERSE index1,
the index2 and index3 port numbers are duplicated.
Duplicate ports exist in REVERSE.YKZ274E MSG SC=36
RC=36 (index1, index2,
index3)
Delete one of the definitions or make sure that the
duplicated port numbers are correct, and then
re-execute the command.
index1
Index number of the duplicated
logical path
index2
Index number of one of the
duplicated ports
index3
Index number of the other
duplicated port
The route list or device number information, required
for processing to continue, is missing.
Necessary Routelist or DEVN
information is not found.
YKZ275E MSG SC=36
RC=36
Correct the value assigned to the ROUTE, DAD or
PATH parameter passed to the YKLOAD command.
Make sure that the specified volume has been
scanned, because this message is output when the
volume for CU and CCA specified in the path set
definition file has not been scanned.
A storage system using a path-controlled device or
Remote Disk Controller control contains an IFType,
Some of the arrays do not support
storage system type paths.
YKZ276E MSG SC=36
RC=36
which is not supported for disc controller-type path
control.
In the configuration file, make sure that the storage
system is controllable (that the first two digits of the
IFType are X'11' or higher). Also, if scanning was
not performed after the storage system microcode
was replaced, perform another scan.
There is a logical path without a physical path
established.
Some paths are in the NOPATH
state.
YKZ277W MSG SC=4
RC=4
Logical paths were detected for which the port
information stored in the REXX variable did not match
Some paths are in the MISMATCH
state.
YKZ278W MSG SC=8
RC=8
the port information set on the storage system. The
port number or number of ports that have been set
is incorrect.
Logical paths containing physical paths in the
INVALID status were detected from a storage system.
Some paths are in the INVALID state.YKZ279W MSG SC=12
RC=12
Table 41 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ28x)
Explanation and Recommended ActionsMessage TextMessage ID
The IFType of a storage system using the Remote
DKC Control Function is smaller than the IFType of
Primary volume's IFType is larger
than Remote control's IFType value.
YKZ280W MSG SC=0
RC=0
the P-VOL defined in the copy group. As such, the
smaller of the two will be used when each command
is executed. Note that on some machine types, some
functionality might be lost. Also, if a scan was not
List of Messages 139