HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 43 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ3x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
For details on error codes, see “Storage System
Sense Byte Information” (page 163)n. If the error code
is not listed in the manual, contact maintenance
personnel.
A dynamic change in an I/O configuration definition
was detected during processing of the command.
A dynamic configuration change was
detected during specified command
processing. DEVN device#
YKZ370E MSG SC=32
RC=32
Check the status of the device targeted by the
command, correct any errors related to the
configuration or execution conditions, and then
re-execute the command.
device#
Device number being processed
when a dynamic change was
detected in an I/O configuration
definition
The YKENV command terminated.YKENV command return
code=return-code.
YKZ371I TSO
return-code
Return code issued by the YKENV
command
Table 44 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ40x)
Explanation and Recommended ActionsMessage TextMessage ID
The parameter indicated by param cannot be
specified for a copy group with a copy type of
copy-type.
param parameter cannot be
specified for copy-type Copy Group.
YKZ400E MSG SC=48
RC=48
Check the copy type and the parameter.
param (string)
The parameter name which
cannot be specified
copy-type (string)
The copy type specified for the
copy group
The storage system which the command is issued
onto, or the storage system which uses the remote
Some of the storage systems do not
support param.
YKZ401E MSG SC=48
RC=48
DKC control function, does not support the parameter
indicated by param.
Use a device which supports the parameter indicated
by param. Also, if a scan has not been performed
after the storage system microcode was replaced,
perform another scan.
param (string)
The parameter name which is not
supported
The copy pair entered an unexpected status while
registering the journal group to EXCTG.
Unexpected transition occurred while
adding JNLG to EXCTG. (CT ID=jj,
YKZ402E MSG SC=44
RC=44
Check that the status to be monitored is correctly
specified. If the status is correctly specified, execute
sub CT ID=kk, MIRROR=m,
SN=ssssssssssss, STATE=nnnn)
List of Messages 149