HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 44 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ40x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
the YKQUERY command to determine the cause of
the problem and rectify the error.
jj (hexadecimal number)
The journal group number specified by the C/T group
ID (00-FF)
kk (hexadecimal number)
The journal group number specified by the sub C/T
group ID (00-FF)
m (decimal number)
Mirror ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
nnnn (string)
The status after the transition
The target copy pair was not found.No pair processed in Copy Groups.YKZ403I MSG SC=0
RC=0
Check the volume status, correct errors involved in
the configuration or execution conditions if any, and
then re-execute the command.
If the YKMAKE SELECT(COND) command is issued
on a copy group container with EXCTG ID specified
but without specifying the DEVN parameter, the
EXCTG registration I/O is issued even if this message
is output.
The number of journal groups in the EXCTG
exceeded the maximum number allowed.
Number of JNLG in the EXCTG
exceeds the limit.
YKZ404E MSG SC=36
RC=36
#
#
If this message is output while the YKLOAD
command is being executed, the RC is 44.
Duplicate journal group numbers were found in the
copy group.
Duplicate JNLG number in the Copy
Group is found. (CT ID=jj, sub CT
ID=kk)
YKZ405E MSG SC=36
RC=36
#
In order to make the journal group pairs over multiple
storage systems correspond to copy groups which
configure a container, use different numbers in one
of the pairs of C/T group ID and sub C/T group ID
which describe the journal group number.
jj (hexadecimal number)
The journal group number specified by the C/T group
ID (00-FF)
kk (hexadecimal number)
The journal group number specified by the sub C/T
group ID (00-FF)
#
If this message is output while the YKLOAD
command is being executed, the RC is 44.
EXCTG cannot be used on a storage system that has
a P-VOL or uses the remote DKC control function.
Primary device IFType does not
support EXCTG.
YKZ406E MSG SC=36
RC=36
#1
Use a device
#2
that supports EXCTG. Also, if a scan
has not been performed after the storage system
microcode was replaced, perform another scan.
IFType
IFType value
150 Messages