HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 44 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ40x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
EXCTG is used in a storage system where the first
two digits of the IFType are X'13' or higher.
EXCTG cannot be used on a storage system that has
a S-VOL or uses the remote DKC control function.
Secondary device IFType does not
support EXCTG.
YKZ406E MSG SC=36
RC=36
#1
Use a device
#2
that supports EXCTG. Also, if a scan
has not been performed after the storage system
microcode was replaced, perform another scan.
IFType
IFType value
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
EXCTG is used in a storage system where the first
two digits of the IFType are X'13' or higher.
An error occurred while the suspend processing using
the CAJ ATTIME suspend function was being
performed.
An error occurred during suspension
of CAJ ATTIME. (CT ID=ii, R-JNL=jj,
GENID=gg, ATTSTS=aa, SISTS=ss,
YKZ407E MSG SC=24
RC=24
Check the error information, and remove the cause
of the error. If necessary, also check the storage
URSTS=uu, CODE=eeee,
TIME=ATTIME-suspend-time)
system log. After that, use the YKSUSPND command
to cancel the ATTIME suspend time, and then acquire
a backup again. See “Multi-line Messages Output
to SYSTSPRT” (page 157) for details.
ii (hexadecimal number)
consistency group ID for BC Z (00-7F)
jj (hexadecimal number)
The journal group number specified for the sub
consistency group ID for the Cnt Ac-J Z that links with
BC Z (00-FF)
gg (hexadecimal number)
Generation ID (00-FF)
aa (decimal number)
Status of ATTIME suspension (0-4)
0: No ATTIME suspend time has been set.
1: The ATTIME suspend time has been set, but
suspension has not been performed yet.
2: Suspension was performed because the ATTIME
suspend time expired.
3: Suspension was performed because the timeout
period expired, or because the Cnt Ac-J Z copy pair
was in the suspend status at the ATTIME suspend
time.
4: Suspension was performed because the system
detected a no-update journal.
ss (decimal number)
Status of ShadowImage (0-3)
0: The suspend processing has not started.
1: The suspend processing is in progress.
2: The suspend processing ended successfully.
List of Messages 151