HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 45 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ41x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Device number defined in the
disk configuration definition file
sn
Serial number of the storage
system on which the device
indicated by devn actually exists
This storage system does not allow Cnt Ac-S Z data
differential-data management units to be specified.
Copygroup SUPFnc does not support
CA Map (DIF UNIT).
YKZ416E MSG SC=36
RC=36
#1
Use a device
#2
that allows Cnt Ac-S Z data
differential-data management units to be specified.
Also, if scanning was not performed after the
storage system microcode was replaced, perform
another scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group
(minimum)
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
Units of Cnt Ac-S Z data differential-data
management units can be specified on storage
systems with the following versions of the storage
system support function:
• XP12000/XP10000 disk array
Version of the storage system support function:
X'11' or higher
• XP24000/XP20000 disk array
Version of the storage system support function:
X'20' or higher
The command cannot be executed for Cnt Ac-S Z
copy groups with the HyperSwap attribute.
This command is invalid for CA Copy
Groups linkaged with HyperSwap.
YKZ417E MSG SC=48
RC=48
Execute the PPRC copy pair operation from TPC-R.
A resynchronization that reverses the copy direction
cannot be performed with the OPENMFUPDATE
OPENMFUPDATE cannot use with
reverse-resync.
YKZ418E MSG SC=48
RC=48
parameter specified. (The OPENMFUPDATE
parameter is used to modify the Open/MF
Consistency attribute.)
Multi-line Messages Output to SYSTSPRT
This section describes the multi-line messages that are output to SYSTSPRT.
In this section, character strings enclosed in angle brackets (< >) are variables.
YK8310I PRT
COPY GROUP : <cgid>
PREFIX : <prefix>
DAD-ID : <dad>
TYPE : <cgtype>
GROUP STATUS : <status>
Multi-line Messages Output to SYSTSPRT 157