HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 55 Details of Error Codes 50xx – 6Axx (continued)
Type of ErrorError DetailsError
Code
OthersPATHCMDCnt Ac-J ZTCACnt Ac-S ZBC Z
Not outputOutputNot outputThe command could not be
executed because the
6A07
corresponding volume is not the
P-VOL of a TCA copy pair or it is
a Non Gen'ed volume.
Not outputOutputNot outputAn ATTIME suspend time for TCA
cannot be set because there is a
6A08
copy pair that is not in the DUPLEX
status.
Not outputOutputNot outputAn ATTIME suspend time for TCA
cannot be set because the specified
6A09
C/T group timer type is not
System.
Not outputOutputNot outputThe command could not be
executed because the TCA
program product is not installed.
6A0F
OutputNot outputThe command could not be
executed because a remote
6A13
command was executed while the
command device was not defined.
OutputNot outputThe command could not be
executed because it was specified
6A14
to be remotely executed, but this
command cannot be executed as
a remote command.
Not outputOutputNot outputThe command could not be
executed because an instruction to
6A16
delete a command device was
issued against a volume that is not
a command device.
OutputNot
output
OutputNot outputThe command cannot be executed
because an un-implemented CU
6A18
number was specified when the
command device was defined or
deleted.
OutputNot outputThe command could not be
executed because a remote control
6A19
command has been received for a
volume that is not a command
device.
OutputNot
output
OutputNot outputThe command could not be
executed because the APID
6A1E
specified by the remote command
does not match the APID that was
already registered.
Details of Error Codes 189