HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 57 Details of Error Codes 8Dxx (continued)
Type of ErrorError DetailsError
Code
OthersPATHCMDCnt Ac-J ZTCACnt Ac-S ZBC Z
command device is a volume used
in the open system.
Not outputOutputNot outputThe command could not be
executed because the logical
8D43
volume of the specified volume is
blocked.
Not outputOutputNot outputThe command could not be
executed because the specified
volume has PIN data.
8D44
Not outputOutputNot outputThe command device cannot be
defined. The reason might be one
of the following:
8D45
• The corresponding volume is
executing a remote control
command as a command
device.
• The corresponding volume is
part of a Cnt Ac-S Z or TCA
copy pair.
Not outputOutputNot outputThe command device cannot be
deleted. The reason might be one
of the following:
8D46
• The corresponding volume is
executing a remote control
command as a command
device.
• The corresponding volume is
part of a Cnt Ac-S Z or TCA
copy pair.
Not outputOutputNot outputThe command could not be
executed because the specified
volume is a BC Z volume.
8D47
Not outputOutputNot outputThe command could not be
executed because the specified
volume is not installed.
8D4D
Not outputOutputNot outputA command device cannot be
defined because it differs from the
APID that was already registered.
8D4E
Not outputOutputNot outputThe command could not be
executed because the specified
volume is online.
8D4F
OutputNot outputNot outputThe host command parameter is
incorrect.
8D50
Not outputOutputNot outputThe command could not be
executed because the logical
8D51
volume of the specified volume is
blocked or the specified volume is
in the NOT READY status.
Not outputOutputNot outputThe command could not be
executed because the logical
8D52
Details of Error Codes 197