HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YK80x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
N/ASee “YK8318I PRT” (page
160).
YK8318I
This message indicates the results of REPORT(STATS) for the Cnt
Ac-J Z copy group.
REPORT STATS:
COPY GROUP : cgid TYPE
: cgtype
YK8319I CON
cgid
DAD-ID : dad PREFIX : prefix
Copy group ID
C/T SUBC/T PSN SSN
TRANS PJMET% PJDAT%
cgtype
Copy group type
SJMET% SJDAT% PJDATA
SJDATA
dad
ctid sub-ctid psn ssn
mcu-to-rcu-kbps p-jnl-meta
Copy group host device address domain ID
p-jnl-data s-jnl-meta s-jnl-data
prefix
p-jnl-data-capacity
s-jnl-data-capacity
Prefix
ctid
Master journal group ID
sub-ctid
Restore journal group ID
psn
Serial number of primary storage system
ssn
Serial number of secondary storage system
mcu-to-rcu-kbps
Data transfer rate (Kbps) between the main
control unit and the remote control unit
p-jnl-meta
Metadata % used in master journal volume
p-jnl-data
Data % used in master journal volume
s-jnl-meta
Metadata % used in restore journal volume
s-jnl-data
Data % used in restore journal volume
p-jnl-data-capacity
Master journal volume data capacity (GB)
s-jnl-data-capacity
Restore journal volume data capacity (GB)
The copy group identified by cgid has switched to the target status
identified by status.
time Copy Group ‘cgid’ has
reached target status ‘status’.
YK8320I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
List of Messages 23