HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 2 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKA0x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
The value specified in the TIMEOUT parameter is invalid.TIMEOUT() value not validYKA007E TSO
If GET or CLOSE is specified in the OP parameter, you cannot
specify the TIMEOUT parameter.
TIMEOUT() parameter
cannot be specified for this
operation
YKA008E TSO
Specify OPEN in the OP parameter, and then specify the TIMEOUT
parameter.
The value specified in the MSGID parameter is invalid.MSGID() value not validYKA009E TSO
If GET or CLOSE is specified in the OP parameter, you cannot
specify the MSGID parameter.
MSGID() parameter cannot
be specified for this
operation
YKA010E TSO
Specify OPEN in the OP parameter, and then specify the MSGID
parameter.
Processing of the YKCONMSG command with OP(GET) specified
exceeded the time specified in the TIMEOUT parameter, but the
No message foundYKA096I TSO
IEA494I console message, IOSHM0414I console message, or
the message specified in the MSGID parameter of the YKCONMSG
command has not yet arrived.
Re-execute the YKCONMSG command with OP(GET) specified after
the system becomes ready to receive messages.
The YKCONMSG command with OP(GET) specified returned the
IEA494I console message, IOSHM0414I console message, or
message-textYKA097I TSO
the message message-text specified in the MSGID parameter of the
YKCONMSG command in the order in which the messages arrived.
The YKCONMSG command with the OP(OPEN) parameter specified
was executed successfully.
From now on, if you execute the YKCONMSG command with the
OP(GET) or OP(CLOSE) parameter specified, use the returned
handle value in handle.
HANDLE(x'handle')YKA098I TSO
The YKCONMSG command with the OP(OPEN) parameter specified
terminated normally.
Close operation completeYKA099I TSO
The YKP2B command terminated.YKP2B completed.
RC=return-code
YKB001I TSO
return-code
The return code of the YKP2B command
0: The command ended successfully. The copy
group definition file was output.
4: Indicates that one of the following occurred:
• The command ended successfully. No copy
pair was detected within the range of the
specified device numbers.
• A copy group definition file was created, but
volume information not defined in the disk
configuration definition file for the site
specified in the DAD parameter was detected
among copy pairs within the range specified
in the DEVN parameter.
• A copy group definition file was created, but
a change was detected in the I/O
configuration when the YKP2B command was
executed with CHECK specified in the HS
parameter.
8: An I/O error occurred in a volume within the
search range. The copy group definition file was
List of Messages 29