HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 2 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKA0x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
created for the volume that was successfully
detected.
44: The processing was cancelled due to an
error. The copy group definition file was not
created.
48: The command ended due to an invalid
parameter.
No copy pair was detected within the specified range. Check the
operating range and status of the copy pair that you want to
No copy pair was
discovered.
YKB002I TSO
acquire, and execute the YKP2B command again. If the copy pair
status is SIMPLEX, the YKP2B command does not detect any copy
pair.
The parameter specification was invalid or missing.Missing or invalid
parameter:
YKB100E TSO
Check the following, and then re-execute the command:
parameter-name
• Make sure that the required parameter indicated by
parameter-name was specified.
• Make sure that the value specified for the required parameter
indicated by parameter-name is valid.
• Make sure that different device address domain (DAD) IDs for
the primary and secondary sites are specified for the DAD
parameter.
parameter-name
Name of the invalid or missing parameter
The specified prefix is being used by another program.The specified PREFIX is
being used by another
program.
YKB101E TSO
Check the value specified for the prefix.
An error occurred during execution of the YKP2B command.Error occurred during
execution.
Cmd=command-name
YKB102E TSO
See the explanation corresponding to the message ID of the error
message indicated by message-text and take appropriate action.
msg=message-text:
message-value:
message-severity
Also see the additional information indicated by message-value
and message-severity again, take appropriate action. If the problem
is not resolved, contact an HP service representative.
command-name
CLI command name
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space
is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space
is displayed.
The error messages message-text, message-value, and
message-severity are displayed in the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
30 Messages