HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 8 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKG2x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
Cnt Ac-S Z with the HyperSwap attribute cannot be used in this
storage system because 2DC configuration with HyperSwap and
This copygroup does not
support LinkageOption=HS.
SUPFNC=SUPFnc
YKH205W TSO
Cnt Ac-J Z is not supported. Use a device
#
in which 2DC
configuration with HyperSwap and Cnt Ac-J Z can be used. Also,
if scanning was not performed after the storage system microcode
was updated, perform a scan.
SUPFnc (hexadecimal number)
Value for the version (minimum value) of the
storage system support function used in the copy
group
#
The following lists the type of storage system for which you can
use 2DC configuration with HyperSwap and Cnt Ac-J Z:
• XP24000 Disk Array
• P9500 Disk Array
Nothing or an invalid value is assigned to the parameter identified
by name.
Unable to execute without
valid name parameter.
YKJ000E TSO
RC=48
name
Parameter name
The parameter identified by name is too long.name parameter is too long.YKJ001E TSO
RC=48
name
Parameter name
The specified prefix is being used by another program.The specified PREFIX is
being used by another
program.
YKJ002E TSO
RC=48
Check the value specified for the prefix.
An error occurred during execution of the YKIMPORT command
or YKEXPORT command.
Error occurred during
execution. Cmd= info
msg= message-text:
message-value:
message-severity
YKJ051E TSO
RC=32
See the error message message-text and resolve the problem. Also
see the additional information indicated by message-value and
message-severity and take appropriate action.
If the acquisition of information denoted by message-text,
message-value, or message-severity fails, FATAL is displayed
instead of the information that should be acquired. The reasons for
FATAL to be displayed include an insufficient region size. Review
the current region size, and then retry executing the command.
If the problem is not resolved, contact technical support for
assistance.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
.
If no additional information is available, a space
is displayed
message-severity
Additional information about the error message
List of Messages 49