HP P9000 for Business Continuity Manager Software Messages (T5253-96055, September 2011)

Table 9 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKL0x) (continued)
Explanation and Recommended ActionsMessage TextMessage ID
An attempt to deallocate the XML file identified by file failed.File Deallocation Failed:
dsstate.
YKL091E MSG
SC=40 RC=40 (file)
dsstate
Status of the input XML
file
file Name of the XML file where the error was
detected
An attempt to read the XML file identified by file failed.File Read error: dsstate.YKL092E MSG
SC=40 RC=40 (file)
dsstate
Status of the input XML
file
file Name of the XML file where the error was
detected
If process-name is YKLOAD:process-name command
return code=max-value,
reason code=reason-code.
YKL099I MSG TSO
The YKLOAD command has finished. This message is always
displayed.
If process-name is YKGETRUT:
The route list definition file and the command device definition file
have been read. This message is output when an invalid route list
definition file or invalid command device definition file are read
in ISPF.
reason-code
Reason code for the returned max-value
max-value
Maximum value among the output return codes
Table 10 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKL2x)
Explanation and Recommended ActionsMessage TextMessage ID
Nothing or an invalid value is assigned to the parameter identified
by name.
Unable to execute without
valid name parameter.
YKL201E MSG
SC=48 RC=48
SYSAUTH. cannot be specified in the MSG parameter. Specify a
different name.
"SYSAUTH". cannot be
specified in MSG()
parameter.
YKL202E TSO
RC=48
SYSAUTH. cannot be specified in the STEM parameter. Specify
a different name.
"SYSAUTH." cannot be
specified in STEM()
parameter.
YKL203E MSG
SC=48 RC=48
The parameter identified by name is too long.name parameter is too long.YKL204E TSO
RC=48
The parameter identified by name is too long.name parameter is too long.YKL205E MSG
SC=48 RC=48
The ROUTE parameter is allowed on the first call of the YKLOAD
command.
Route parameter is allowed
only on 1st call of YKLOAD
YKL206E MSG
SC=48 RC=48
The XML attribute identified by attname has already been defined.The attribute attname is
already defined.
YKL241W MSG
SC=4 RC=4
(file:rec#)
Review the file name identified by file and the attname value on
the line with the line number identified by rec#.
attname
62 Messages